Conair S900II System Technical Information PDF herunterladen (Seite 30)

S900–II USER MANUAL

Version 2.1 |–>

IV – Starting–up

01T01518_1

25.11.99

IV – 4. Operation without the robot

This operation mode enables the IMM to operate autonomously.

It is possible to select the “Without robot” mode via :

 the “With or without robot” key on the cabinet,

 the key on the pendant keyboard and on the BRP (optional).

IV – 4. 1. The “without robot” key

Note : This key can be found on the pendant keyboard and on the BRP box (optional).

This key enables the IMM to be used without the robot. When the robot is in automatic, it will stop

at the end of the cycle if the

key is pressed.

The key flashes until the robot stops. When the key is continuously lit up, the “without robot” mode

is selected.

The mode is validated by pressing

. The IMM movements are only authorized once this key

has been pressed.

To quit the “Without robot” mode, the

key must be pressed a second time (the light will no

longer be lit up).

IV – 4. 2. The “With or without robot” key

You are advised to only use this key if the robot is stopped for a long time, for example, during

production without the robot. It is then possible, if the robot is stopped at the end of the beam on the

“Tool change position” (PCO) cam, to power–down the robot cabinet.

If the key is moved to the “Without robot” position, the robot will stop at the end of the cycle as

described in chapter IV – 4. 1. page 25.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 64 65

Keine Kommentare

Conair S900II System Technical Information Seite 30