Conair S900II System Technical Information PDF herunterladen (Seite 36)

Programming S900–II Level 1

Version 2.2 |–>

III – Program structure

01T01527_2

25.5.00

So that the cycle time optimalization is efficient, some of the IMM adjustment parameters must be

checked or modified :

 the Partial Opening position (OPA) must be adjusted to authorise the robot arm’s

descent as soon as possible (avoiding any risks of collision)

 the IMM movement speeds and accelerations (mould, ejectors and core pullers) must

be optimised to a maximum, whilst at the same time respecting the quality of the parts

produced and the safety of the equipment.

 if possible, the fastest movements must be respected : for example, if the mould opening

is quicker than the part ejection, the cycle time will be less penalised if the opening

is large enough to mask the ejectors and/or core pullers back and forward time during

the robot movements.

Reminder : the equipment’s productivity is calculated over long production periods. Consequently, stops

due to incidents are taken into account.

 An efficient cycle time optimalization MUST :

 Reduce the part fabrication time

 An efficient cycle time optimalization MUST NOT :

 Increase the number of reject parts

 Increase the number of incidents

Sepro proposes, as an option, an additional means of cycle time optimalization : anticipated restart that

enables you to mask the IMM reaction time (see chapter V – 5. page 64).

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 81 82

Keine Kommentare

Conair S900II System Technical Information Seite 36