Conair MPW Spezifikationen PDF herunterladen (Seite 72)

Press the up

▲▲

key to begin calibrating.

The controller displays the name of the current calibration

(examples: 32 SC.L; 32 rC.L; 510 SC.H; or 510 rC.H).

Wait until the control displays “don” or “bad.”

A “don” message in the Setpoint display indicates the cali-

bration was successful. A “bad” message in the Setpoint

display indicates a bad calibration.

Press Select to start the next calibration.

Pressing and releasing the Select key at the end of a

calibration tells the controller to perform the next calibra-

tion.

Exit Calibration Mode.

Press and hold the Select key for 3 seconds to exit the

Calibration Mode.

You can now proceed to the next test in Test Mode, or

disable Test Mode and resume normal operation.

CALIBRATING

TEMPERATURE

SENSORS

UGH015/0100 Thermolator TW-1 and TW-2

MAINTENANCE 5-11

NOTE: The original calibration value stored in

EEProm can be restored for the current calibration

by pressing the STOP key at any time.

TO DISABLE TEST MODE, complete steps 2

through 5 in “Performing System Tests”, setting dip

switch 6 to OFF instead of ON.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 118 119

Keine Kommentare

Modèles	Type de document
CDA2	Manuel de l'utilisateur Christie CDA2 User manual, 28 pages
Vive Audio CDA5	Manuel de l'utilisateur Amplificadores Christie Vive Audio CDA5/CDA7.5 [en] , 27 pages Manuel de l'utilisateur Christie Vive Audio CDA5 User manual, 27 pages

Conair MPW Spezifikationen Seite 72