Conair FC-33 Spezifikationen PDF herunterladen (Seite 13)

Appendix l AA-13

DM LO ALARM SETPOINT

SET 150°F

Setting the Low Alarm Setpoint

SCREEN C (DM-II LOW ALARM SETPOINT)

1 This screen displays an automatically calculated value of the process tempera-

ture minus the offset screen “D”, see the drying monitor control function flow

charts and descriptions later in this manual, minus ½ the band on screen “E”, see

the drying monitor control function flow charts and descriptions later in this manu-

al. This alarm setpoint will move up or down based on your process setpoint tem-

perature.

4 5

Clear

Enter

djust Setpoint

cknowledge

larm

Start

Stop

elect

Category

enu

croll List

rev

ext

uto Start

ewpoint Control

et-Back Temp.

Process Blower

Process Heater

Regen. Blower

Regen. Heater

Clear

Enter

Adjust Setpoint

Numeric Keypad

Increment/Decrement Buttons

NOTE: If you choose an RTD that is too high in hopper, there is a chance that you will get a

nuisance alarm when new "cold" material is loaded into the hopper. To avoid the nuisance

alarm you can: choose a different RTD located lower in the hopper; adjust the alarm band

(open up the tolerance); move the alarm setpoint or increase the temperature offset.

✐

NOTE: You can choose to accept this value or change it (within the established band limits,

see page AA-27 later in this manual) based on your processing needs. To change the value,

push the select category button under the displayed value so that it begins flashing/blinking,

then use either the numeric keys to enter a new value or the +/- (Increment/ Decrement)

buttons can be used to change the value. Holding the +/- buttons will cause the number to

ramp up or down faster the longer the button is held. Once the new value you have selected

appears in the display push enter.

✐

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Conair FC-33 Spezifikationen Seite 13

Kommentare zu diesen Handbüchern